Welcome to the NavList Message Boards.

NavList:

A Community Devoted to the Preservation and Practice of Celestial Navigation and Other Methods of Traditional Wayfinding

Compose Your Message

Message:αβγ
Message:abc
Add Images & Files
    or...
       
    Reply
    Re: Example sights very near the North Pole
    From: Gary LaPook
    Date: 2017 Jun 6, 13:58 -0700

    For flight navigation near the pole (there were a lot more flights in that region than ship voyages) it was common to use the pole as the AP.

    AFPAM 11-216  2001

    Section 12E— Celestial Navigation in High Latitudes

    12.16. Basics. Celestial navigation in polar regions is of primary importance because (1) it constitutes a primary method of determining position other than by DR and (2) it provides a reliable means of establishing direction over much of the polar regions. The magnetic compass and directional gyro (DG) are useful in polar regions, but they require an independent check, which can be provided by a celestial body or other automatic systems such as INS or GPS.

    272 AFPAM11-216        1 MARCH 2001

    12.16.1. At high latitudes, the sun's daily motion is nearly parallel to the horizon. The motion of the aircraft in these regions can easily have greater effect upon altitude and Zn of the sun than the motion of the sun itself.

    12.16.2. At latitude 64o, an aircraft flying west at 400k keeps pace with the sun, which appears to remain stationary in the sky. At higher latitudes, the altitude of a celestial body might be increasing at any time of day, if the aircraft is flying toward it and a body might rise or set, at any azimuth, depending upon the direction of motion of the aircraft relative to the body.

    12.17. Bodies Available for Observation. During the continuous daylight of the polar summer, only the sun is regularly available for observation. The moon is above the horizon about half the time, but generally it is both visible and at a favorable position with respect to the sun for only a few days each month.

    12.17.1. During the long polar twilight, no celestial bodies may be available for observation. As in lower latitudes, the first celestial bodies to appear after sunset and the last to remain visible before sunrise are those brighter planets, which are above the horizon.

    12.17.2. The sun, moon, and planets are never high in polar skies, thus making low altitude observations routine. Particularly with the sun, observations are made when any part of the celestial body is visible. If it is partly below the horizon, the upper limb is observed and a correction of -16' for semidiameter (SD) is used in the SD block of the precomputation form.

    12.17.3. During the polar night, stars are available. Polaris is not generally used because it is too near the zenith in the arctic and not visible in the Antarctic. A number of good stars are in favorable positions for observation. Because of large refractions near the horizon avoid low altitudes (below about 20o) when higher bodies are visible.

    12.18. Sight Reduction. Sight reduction in polar regions presents some slightly different problems from those at lower latitudes. Remember, for latitudes greater than 69o N or 69o S, Pub. No. 249 tables have tabulated Hcs and azimuths for only even degrees of LHA. This concerns you in two ways. First, it will be necessary to adjust assumed longitude to achieve a whole, even LHA for extractions. This will preclude interpolating. Second, the difference between successive, tabulated Hcs is for 2o of LHA, or 8 minutes of time, so this difference must be divided in half when computing motion of the body for 4 minutes of time.

    12.18.1. For ease of plotting, all azimuths can be converted to grid. To convert, use the longitude of the assumed position to determine convergence because the Zn is for the assumed position, not the DR position. On polar charts, convergence is equal to longitude.

    12.18.2. In computing motion of the observer, it is imperative that you use the difference between grid azimuth and grid track, or Zn and true track, since this computation is based on relative bearing (RB). Zn minus grid course does not give relative bearing.

    12.18.3. Since low altitudes and low temperatures are normal in polar regions, refer to the refraction correction table and use the temperature correction factor for all observations.

    12.18.4. In polar regions, Coriolis corrections reach maximum values and should be carefully computed.

    AFPAM11-216        1 MARCH 2001 273

    12.19. Poles as Assumed Positions. Within approximately 2o of the pole, it is possible to use the pole as the assumed position. With this method, no tabulated celestial computation is necessary and the position may be determined by use of the Air Almanac alone.

    12.19.1. At either of the poles of the earth, the zenith and the elevated poles are coincident or the plane of the horizon is coincident with the plane of the equator. Vertical circles coincide with the meridians and parallels of latitude coincide with Dec circles. Therefore, the altitude of the body is equal to its Dec and the azimuth is equal to its hour angle.

    12.19.2. To plot any LOP, an intercept and the azimuth of the body are needed. In this solution, the elevated pole is the assumed position. The azimuth is plotted as the GHA of the body, or the longitude of the subpoint. The intercept is found by comparing the Dec of the body, as taken from the Air Almanac, with the observed altitude of the body. To summarize, the pole is the assumed position, the Dec is the Hc, and the GHA equals the azimuth.

    12.19.3. For ease of plotting, convert the GHA of the body to grid azimuth by adding or subtracting 180o when using the North Pole as the assumed position. When at the South Pole, 360o – GHA of the body equals grid azimuth. The result will allow the use of the grid lines for plotting the LOPs. When using grid azimuth for plotting, apply Coriolis to the assumed position (in this case, the pole). Precession or nutation corrections are not necessary since current SHA and Dec are used. Motion of the observer tables may also be used in precomputation, since grid azimuth relative to grid course may be determined. Motion of the body is zero at the poles.

    12.19.4. Note the exact GMT of the celestial observation. From the Air Almanac, extract the proper Dec and GHA. Plot the azimuth. Compare Ho and Hc to obtain the intercept. When the observed altitude (Ho) is greater than the Dec (Hc), it is necessary to go from the pole toward the celestial body along the azimuth. If the observed altitude is less than the Dec, as is the case with the sun in Figure 12.15, it is necessary to go from the pole away from the body along the azimuth. Draw the LOPs perpendicular to the azimuth line in the usual manner. Don't be concerned about large intercepts; they have no bearing on the accuracy of this type of fix. Observations on well-separated bearings give a fix that is as good close to the pole as it is anywhere else.

    -------------------------------------------------

    See attached from 1951 Air Force Manual 51-40



    File:
    Pole-AFM-51-40-(1951).pdf

       
    Reply
    Browse Files

    Drop Files

    NavList

    What is NavList?

    Join NavList

    Name:
    (please, no nicknames or handles)
    Email:
    Do you want to receive all group messages by email?
    Yes No

    You can also join by posting. Your first on-topic post automatically makes you a member.

    Posting Code

    Enter the email address associated with your NavList messages. Your posting code will be emailed to you immediately.
    Email:

    Email Settings

    Posting Code:

    Custom Index

    Subject:
    Author:
    Start date: (yyyymm dd)
    End date: (yyyymm dd)

    Visit this site
    Visit this site
    Visit this site
    Visit this site
    Visit this site
    Visit this site